First, you must assign all your buffs skill into F-Key slot (in Flyff). Let's say F1-Patience, F2-Beef Up, F3-Cats Reflex, F4-Heap Up, F5-Canon, F6-Accuracy, F7-Protect, F8-Spirit Fortune. All of them is using slot key no.2. Now in BuffPang[H], start with selecting your Flyff Id (start your Flyff or the list will be empty). At Slot Key, select 'Slot 2', under Sequential Keys Group. At F-Key, select 'F1'. At Select Job Id, choose 'New Id'. At Interval, enter 300000ms. (means 5mins x 60 = 300sec interval) Press 'Add as Sequential Key Job'. Up to this part, you just finished with inserting your F1-Patience buff. Now, check the entry of 'Select Job Id'. You will notice there is a new entry to this list. Select the new entry. (Should be 'Job 0' if you just jumped to this example, or 'Job 1' if you are following this example from the very beginning. The Id number is incremental) To insert your F2-Beef Up buff, select F-Key to 'F2'. Let the Slot Key remain as it is. Change the value of 'Job Gap' to 2000ms (means 2seconds) Press 'Add as Sequential Key Job'. Up to this part, you just finished with inserting your F2-Beef Up buff. The content of Job Id also change as you pressed 'Add as Sequential Key Job'. Repeat these step, starting with adding the F2-Beef, until all your buffs are in the same Job Id. Check with Job Id content if you are unsure. Finally, press 'Start All' button at top-right of BuffPang. Now check your Flyff char. Your char will start rebuffing itself every 5mins, with 2 seconds delay between buff. Voila..!! How to set up Invoke command for your Auto Buffer Job. Hi guys It's about time to continue grinding as usual. I've been busy lately, and can hardly have free time for myself. The Beta 2.0 Rev 2 has been out for a while, but major bugs could only be confirmed until last week.. Flyff Auto Tools BuffPang[H] - Working 2.0 Beta Rev 2 - New Updates (Sept 20th '10) 2.0 Beta - New Updates (June 3rd '10).